Submissions

Online Submissions

Already have a Username/Password for Jurnal Pengabdian Masyarakat Progresif Humanis Brainstorming?
Go to Login

Need a Username/Password?
Go to Registration

Registration and login are required to submit items online and to check the status of current submissions.

 

Author Guidelines

All papers submitted to the journal Abdimas PHB should not have been published or submitted for publication elsewhere. The official language of the manuscript to be published in JAPHB is Bahasa Indonesia and English.

1. GENERAL AUTHOR GUIDELINES
All manuscripts must be submitted to Abdimas PHB Editorial using Online Submission at e-Journal portal address: http://ejournal.poltektegal.ac.id/index.php/abdimas where author register as Author by online. If authors have any problems on the online submission, please contact Editorial Office at the following email: abdimas@poltektegal.ac.id

2. MANUSCRIPT TEMPLATE
Manuscript should be prepared according to the following author guidelines in the MS Word article template. download the template of the Abdimas PHB in here: Template Journal

4. REVISION OF MANUSCRIPTS
Manuscripts sent back to the authors for revision should be returned to the editor without delay. Revised manuscripts can be sent to editorial office through the Online Submission or email: abdimas@poltektegal.ac.id. The revised manuscripts returned later than 1 (one) months will be considered as new submissions.

 5. AUTHOR FEE
Authors should pay any processing and submission fees for article processing Rp 350.000. Readers can read and download any full-text articles for free of charge.


6. SYSTEMATICS ARTICLE

a. Manuscript Heading, Font, and Spacing

The manuscript should be typed using Microsoft Word (doc/docx). The font used throughout the paper is Arial. The paper size is A4 (i.e., 210 x 297 mm), two-column format with a 1.9 cm margin at the top, a 4.3 cm margin at the bottom, 1.5 cm margin on the left, and 1.5 cm margin on the right. Lines are one spaced, justified. Page numbers should be included in the text located in the footer section of each page. Use of pronouns such as I, we, etc. is to be avoided.

 

b. Title and Author

Title typed bold with a capital letter at the beginning of each word, except conjunction. Title consists of 12 words maximum (with no conjunction). The title should be accurate, unambiguous, specific, and complete. Do not contain infrequently-used abbreviations.

Author’s name typed in full name, no title, affiliation address of author. Give ' * ' symbol for correspondence author. Write Author(s) names without a title and professional positions. Do not abbreviate your last/family name. Always give your First and Last names. Write clear affiliation of all Authors. Affiliation includes a name of department/unit, (faculty), a name of university, country.

 

c. Abstract and Keywords

Abstract contain the objectives of the research, method, result and discussion of the research which compiled in one paragraph with essay format not enumerative. No citation in abstract. Content are 160 - 250 words Maximum and write in English and Indonesia.

 

d. Content of Manuscript

Manuscript submitted to this journal should follow the heading below, except for the review article: 

  • Title;
  • Authors Name; Authors Affiliation; Authors  email;
  • Abstract (Indonesia); Keywords;
  • Introduction; 
  • Related research;
  • Methods;
  • Results and Discussion;
  • Conclusions and Suggestions;
  • Acknowledgments; and 
  • References.

 

e. References

Cite the main scientific publications on which your work is based. Cite only items that you have read. Avoid excessive self‐citations. Avoid excessive citations of publications from the same region. Check each reference against the original source (authors name, volume, issue, year, DOI Number). Reference use IEEE Style reference citation.

Reference provisions:

  1. Primary reference source are journal, patent, dissertation, thesis, paper in proceeding and text book.
  2. Referral source as much as possible the libraries last 10 years.
  3. Should avoid the using of reference within another reference, popular text book, and internet reference except e-journal and government or private institute.
  4. Abstract are not allow to be reference.
  5. Reference numbering format is [1],[2],[3],…and so forth, numbered according the loading order reference in the script.
  6. Reference citation within text only typed in number (not author or year), example: ".... (Government to Business), serta pemerintah dengan instansi pemerintah [1]. Selain itu standarisasi eGovernmentmenjadi lebih detail dengan mengacu kepadastandarisasi model data dan interface yang akan diimplementasikan [2].... ".

 

Reference citation should be following this order below:

Journal Article

[1] Wang, T., Gao, H. and Qiu, J., 2016. A combined adaptive neural network and nonlinear model predictive control for multirate networked industrial process control. IEEE Transactions on Neural Networks and Learning Systems, 27(2), pp.416-425.

[2] Syarif, I., Prugel-Bennett, A. and Wills, G., 2016. SVM Parameter Optimization using Grid Search and Genetic Algorithm to Improve Classification Performance. TELKOMNIKA (Telecommunication Computing Electronics and Control), 14(4).

 

Electronic Publication, Information from the internet

[3] L. Weiss, Instruction to Authors, Elsevier Publishing,

http://www.elsevier.com/authors.html, 1999, (diakses: May 13, 2010)

 

Conference Proceeding/Workshops

[4] Xiaohui, Y., Wuzhi, Z., Xinli, S., Guoyang, W., Tao, L. and Zhida, S., 2016, October. Review on power system cascading failure thoeries and studies. In Probabilistic Methods Applied to Power Systems (PMAPS), 2016 International Conference on (pp. 1-6). IEEE.

[5] Yuan, C., Ng, K.A., Xu, Y.P., Yen, S.C. and Thakor, N.V., 2016, January. 2015 IEEE Asian Solid-State Circuits Conference, A-SSCC 2015-Proceedings. In Institute of Electrical and Electronics Engineers Inc.

 

Monograph, edited book, book

[6] Das, J.C., 2016. Power system analysis: short-circuit load flow and harmonics. CRC press.

[7] DeLone, W.H. and McLean, E.R., 2016. Information Systems Success Measurement. Foundations and Trends® in Information Systems, 2(1), pp.1-116.

[8] Houghtalen, R.J., Osman, A. and Hwang, N.H., 2016. Fundamentals of hydraulic engineering systems. Prentice Hall.

 

Theses, Dissertation

[9] Zaremba, S.M., 2017. The Application of Human Systems Integration in DoD Design (Doctoral dissertation, The George Washington University).

[10] Weerasinghe, M.A.H.D.P., 2016. Artificial Neural Network Based Credit Limit Prediction System for Credit Cards (Doctoral dissertation).

 

Patent

[11] Fukuoh, C., Tajima, H., Tomono, K. and Inagaki, T., Konica Minolta, Inc., 2016. Image processing apparatus, screen display control method, and recording medium. U.S. Patent 9,369,596.

 

Submission Preparation Checklist

As part of the submission process, authors are required to check off their submission's compliance with all of the following items, and submissions may be returned to authors that do not adhere to these guidelines.

  1. The submission has not been previously published, nor is it before another journal for consideration (or an explanation has been provided in Comments to the Editor).
  2. The submission file is in OpenOffice, Microsoft Word, RTF, or WordPerfect document file format, not PDF.
  3. The text is single-spaced; uses a 11-point font Time News Roman; employs italics, rather than underlining (except with URL addresses); and all illustrations, figures, and tables are placed within the text at the appropriate points, rather than at the end.
  4. References have more than 10 references, use Mendeley software and similiar software. Reference use IEEE Style reference citation.
  5. The text adheres to the stylistic and bibliographic requirements outlined in the Author Guidelines, which is found in About the Journal.
  6. Plagiarism check results using Turnitin / Ithenticate do not exceed 35% (along with commitment to reducing Ithenticate by a maximum 20% during the revision process)
 

Copyright Notice

Authors who publish with this journal agree to the following terms:

  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

 

Privacy Statement

The names and email addresses entered in this journal site will be used exclusively for the stated purposes of this journal and will not be made available for any other purpose or to any other party.

 

Author Fees

This journal charges the following author fees.

Article Submission: 0.00 (IDR)
Authors are required to pay an Article Submission Fee as part of the submission process to contribute to review costs.

Article Publication: 350000.00 (IDR)
If this paper is accepted for publication, you will be asked to pay an Article Publication Fee to cover publications costs.

If you do not have funds to pay such fees, you will have an opportunity to waive each fee. We do not want fees to prevent the publication of worthy work.